Trick or treat halloween coloring pages

Published at Thursday, 12 March 2020.

Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. The term paint is used to include paints, varnishes, enamels, shellacs, lacquers, and stains. • Paints are composed of mineral pigments, organic vehicles, and a variety of thinners all combined. • Varnishes are resins dissolved in organic thinners. • Enamels are pigmented varnishes. • Shellac is lac gum dissolved in alcohol. • Lacquers may be both pigmented or clear - the liquid portion usually is treated nitrocellulose dissolve in thinners. • Stains may be pigmented oil or a penetrating type. Many of these materials, such as paints, varnishes, and lacquers, are formulated for specific purposes: • Outside house paints and exterior varnishes are intended to give good service when exposed to weathering • Interior wall paints are formulated to give excellent coverage and good wash-ability. • Floor enamels are made to withstand abrasion. • Lacquers are formulated for rapid drying. • There are also formulas which provide extra self-cleaning, fume- resisting, waterproofing, hardening, flexibility, mildew-resisting, resistance to fading, and breathing qualities. STENCILING. You may want designs on the walls, or perhaps even on floors and ceilings, in some of the rooms or hallway. You may buy or make your own stencils, which should be on heavy paper, stencil board, plastic, or metal. Avoid stencils made of lightweight paper which will get soaked when touched by wet paint. Your paint dealer will suggest the best paint for you to use, as it will depend a great deal on the surface over which you want to put the stenciled designs. Generally a heavy paint is used, so that it will not spread under the stencil while you are applying it.

Painting trim is normally done by roller and brush, not sprayed, so more manual labor is required painting trim, and most cases costing 60% of the total exterior painting job. And, its never been more important to know your colors. Why? Because color is back in a big way! Just look at the vast variety of colors in the department stores. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Paint Selection. Most paints are purchased ready-mixed but, in their selection, consideration should be given to the fact that surfaces vary in their adaptability to paint and atmospheric or other conditions having an adverse effect on paint performance. In addition to the normal weathering action of sun and rain, outside house paints are sometimes exposed to other attacking elements, such as corrosive fumes from factories or excessive amounts of wind-driven dust.