Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint.
Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled.
Now that you have primed the airless, make sure that there isn't a tip in the gun of the airless and bring it over to the empty bucket. Since there is typically cleaning solution in the hose leading to the gun it is a good idea to spray that out until you see thick paint coming out. Once you have thick paint coming out you may put your tip back in. Remember that the tip will have an arrow on one side of the handle that shows which direction it must be in, in order to spray.
Technical advancements are constantly being made to improve the life span, durability, wear and performance of exterior paints. The Akrylatfarg range at Ray Munn, for example, is an environmentally sound water-based option.
Special paints have been innovated from different consumer insights and brilliant paint technology that allows specific paints for specific needs.
If you have large holes or cracks in a wall purchase a small can of vinyl repair paste. The reason I prefer it over regular wall Spackle is that after it dries it is much harder and sands easily. You can even use it for minor wood repair in a pinch.
A flat, semi-gloss, or high-gloss finish may be applied to the primed surface. For a flat finish, two coats of flat wall paint should follow the priming coat. For a semi-gloss finish, one coat of flat wall paint and one coat of semi-gloss paint should be applied to the primed surface. For a high-gloss finish, one coat of semi-gloss paint and one coat of high-gloss enamel should be used over the priming coat.