Hope this helps you in deciding complete exterior paint job, or partial trim only exterior paint job, saving painting costs when you can, from your local area painting contractor.
Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Are the contours rough or concealed?
Purchase paint pan liners 5 for about $5. Once your done simply throw the liner out saving your paint pan and also giving you the opportunity to change paint colors without having to clean and dry the pan.
A High-gloss paint is highly reflective and works well for highlighting details, such as trim and decorative molding. They are also the best choice for doors and cabinet - or any area that sees a high volume of abuse.
One-coat flat paints are organic-solvent-thinned paints intended to accomplish priming, sealing, and finish coating in one operation. They are often sold in thin paste form so that additional inexpensive thinner may be added and mixed before application to increase the volume of paint by one-fourth or more.