Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it. Practically every manufacturer has a "color system," a fat book of color chips with instructions for duplicating each chip. This is accomplished by intermixing cans of colored paint, by adding a concentrated color to a can of white or colored paint, or by adding concentrated color or colors to a can of neutral "base" paint. And for those who don't want any guesswork there's the Color Carousel that mixes the paints right in the store. Whatever the method, the result is a range of colors such as no amateur painter has seen. Another popular color wheel called the Munsell color wheel, is slightly more involved. Instead of 6 basic colors, the Munsell wheel consists of ten colors: red, yellow-red, yellow, yellow-green, green, blue-green, blue, blue-violet, red-violet and violet.
Colors that are equally removed from a reference color are triadic colors. Since these color schemes can become too intense, unless they are very toned down, they are very problematic to manage. This color combination works well in a child's room, and it can be used effectively in a kitchen. Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk. With the new outside rollers, you can paint an average-size house in a couple of days. Add an extension handle and you can roll a terrace without stooping down, reach a roof without leaving the ground. Purchase paint pan liners 5 for about $5. Once your done simply throw the liner out saving your paint pan and also giving you the opportunity to change paint colors without having to clean and dry the pan.