Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow.
Also, when checking the paint, be realistic and don't ignore areas just for the sake of convenience. It will cost you more in time and money later. Typically if one area of the paint is cracked or peeling, then the paint on the entire car is suspect. Maybe the rest of the car just hasn't quite reached that point of decay, but it will shortly. So if you only fix areas that look bad, you'll likely find that you wasted a paint job when the other areas start to crack or peel in a year or two.
The leading brands now flag up paints with lower VOCs and produce paints that are virtually odour-free - the Breatheasy range by Crown is one example. Most leading brands now produce high-quality water-based acrylic paints which outperform the older technologies of vinyl and oils.
Cement-water paints are best suited for application to basement walls which are damp as a result of leakage or condensation. To apply these paints, the same procedure should be followed as is described here for painting exterior masonry walls.
There are two bases of paint for your house: solvent-based (oil or alkyd) and water-based (latex). Oil-based paints dry slow - usually taking up to 24 hours. The best clean up for an oil-based paint is turpentine or paint thinner. Latex paints' advantage is that it dries relatively fast, but it is not desirable in hot weather or direct sunshine. The best clean up for latex paints requires just soap and water. So if you are painting the inside of your house, it is recommended to use water-based paints, while solvent-based paints are suggested for painting the exterior of your house.
Usually on exposed air ducts of galvanized metal a primer coat of zinc dust-zinc oxide paint is used, before the finish coat is applied.
But a Bogus Sample Card Equals Bogus Paint Colors. Of course, there's nothing wrong with stacking sample cards in the color wheel display so that the most attractive colors are the most visible. The problem occurs because so many of those bold, dramatic, "attractive" colors are basically useless as paint colors in your home!