Now here comes the fun part doors and wood work. This is where most people opt to use latex which is a huge mistake. Your home is your biggest investment don't cut corners on it's aesthetics. You want the finish on your woodwork to stand out from the walls especially if you have crown moulding or waynes coating. Don't be fooled by water based products that claim to give the look and finish of oil. It's just good marketing preying on people's fears of painting with oil. Don't believe the hype as those samples they show you have 3 or 4 coats that have been professionally sprayed in a dust free environment. You will not get the same results I can promise you that. You have a choice of semi-gloss or gloss finish. I prefer gloss because to me it gives you a bit more durability and shine. Either one will be fine for your project. Now let's get started.
To balance color, you must grasp the interconnectedness of color schemes. All color interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
Don't ask friends to help you paint. Basically, you are asking them to give up their day off to save you money. You don't want to be first on the list when your painting buddy hits you up to help him move do you?
Plaster. New dry plaster in good condition, which is to be finished with a paint other than water paint, should be given a coat of primer-sealer and allowed to dry thoroughly before being inspected for uniformity of appearance. Variations in gloss and color differences in the case of tinted primers indicate whether or not the whole surface has been completely sealed. If not, a second coat of primer-sealer should be applied. If only a few "suction spots" are apparent, a second coat over these areas may be sufficient.
When you have all the tools at hand, examine your exterior. You might find exterior painting problems, which could be any of the following: alligatoring, blistering, chalking, chalk run down, crackling, dirt pickup, efflorescence, fading, frosting, lapping, mildew, nail head rusting, paint incompatibility, peeling, poor alkali resistance, poor adhesion, poor gloss retention, surfacent leaching, staining, vinyl siding wrap, wax bleed, or wrinkling.
You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one.
We've devised a simple, full proof way to determine whether you are Light or Deep. Look at your overall complexion, eye and hair color. On a scale of 1 to 10, with 1 being the lightest and 10 being the deepest, determine where you fit. So, a 1 would be the palest Nordic complexion with light blond hair. A 10 would be the deepest ebony skin tone and dark or black hair. So, for example: most Mediterranean and Middle Easterners have dark eyes and deep skin and are, therefore, Deep. Most Northern Europeans have blonde hair and light eyes and are Light. Where do you fall? Give yourself a number. If you fall anywhere from 1 to 4 then you are a Light. If you are 5 or greater you are on the Deep side.