Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel.
Paint should not be applied to a concrete basement floor until the concrete has aged for at least a year. The floor should be dry when painted, the best time for application being during the winter or early spring (assuming there is some heating apparatus in the basement), when the humidity in the basement is low. In general, three coats of paint are required on an unpainted floor, and the first coat should be thin to secure good penetration. After the paint is dry, it should be protected with a coat of floor wax.
Either edge of trim is painted with body color, and is where caulking is applied at most 90 degree angles. Painting trim only, cannot feasibly include caulking, as this fails and opens up over time. Most homes need new caulking when painting the exterior, and a close inspection can determine.
Scuff for paint. Once your Mustang is totally stripped of exterior chrome it's time to scuff up the existing paint. The paint shop should do this also, but on the lower end paint packages they won't spend much time here. It's better for you to do it so you know it's done thoroughly.
Painting ceiling does not require premium paint. You can use flat $15 to $20 ceiling paint. I use Sherwin Williams PRO-MAR 200. Painting ceiling requires a lot of physical work and plenty of drop cloths. If you are not up for the challenge or have very high ceilings contacted a professional will prove to be a smart move.
After the siding of your home is painted you can now start on painting the trim. There are a couple different ways you can go about painting the trim of your house. The first way is to mask off all of the trim so that you can merely spray the trim color on to your house, and the second way is to roll the trim by hand. If you are the only person painting the house I would recommend rolling the trim by hand. The reason being is because it takes a long time to mask off all of the trim on your home compared to just rolling the face of the trim boards. If you have multiple people, it would be faster to have the helpers mask everything off while you start spraying the trim color.
Mixing. Paste paints, such as aluminum, resin-emulsion, and lead-in-oil, should be stirred with a stiff paddle and reduced to painting consistency with the liquids recommended on the manufacturer's labels.