Coloring pages of pictures

Published at Saturday, 9 May 2020.

Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat. Remove side view mirrors (unless they're to be body color) as well as exterior door handles and locks. This will take some extra time because you need to remove the interior door panels to get these off, but it's worth it. Head lights, tail lights, marker lights and license plates should come off too, but you'll need them in place to drive to the paint shop. So bring some tools so you can quickly take these off once you arrive. Depending on the year Mustang you can just take off the chrome bezels or rings. The shop can then easily mask the headlight or tail light itself and still get plenty of paint around the edges. Also, when checking the paint, be realistic and don't ignore areas just for the sake of convenience. It will cost you more in time and money later. Typically if one area of the paint is cracked or peeling, then the paint on the entire car is suspect. Maybe the rest of the car just hasn't quite reached that point of decay, but it will shortly. So if you only fix areas that look bad, you'll likely find that you wasted a paint job when the other areas start to crack or peel in a year or two.

Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint. Alkyd is an old interior paint made newly popular by a change in solvent - a super-refined petroleum chemical that has almost no odor. It is not a water paint. You thin it and clean brushes with mineral spirits or turpentine, or, if you want to retain the odorless feature, with the new odorless solvent. (Ask the paint-store man for just that, odorless solvent). Have plenty of newspaper around. After you clean your brushes wrap them in a plastic bag. Painting ceiling does not require premium paint. You can use flat $15 to $20 ceiling paint. I use Sherwin Williams PRO-MAR 200. Painting ceiling requires a lot of physical work and plenty of drop cloths. If you are not up for the challenge or have very high ceilings contacted a professional will prove to be a smart move.