In this section are some tips on techniques and tools that make it easier to paint your house than ever before - not the way the "pro" does, perhaps, but with much the same results.
Cheaper then doing it yourself. Some would argue that if you're going to all the trouble to fully prep the car yourself, then why not just shoot the paint as well? Why get a shop involved? The answer is simply that you'll get a better job and for less money. Some would argue with this, but the fact is that if you've never sprayed a car before then your first car will have a steep, and expensive learning curve. Laying down an even, consistent coat of paint takes considerable practice. Also, paint and equipment is not cheap. You'll need to buy primer, color coat, clear coat, reducers & catalysts. None of these are inexpensive and you can easily spend as much in paint materials alone as the cheapest paint job at Maaco or similar shop.
Limewash - Made from slaked lime and water, this paint is good for porous surfaces such as brickwork, render and plaster and gives a chalky finish. It is available from specialist companies.
Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly.
You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one.
For localities where such conditions exist, self-cleaning paints should be selected. These paints are usually so designated on the label. Concrete, plaster, and metal surfaces each present special problems in painting. For instance, paint for use on masonry or new plaster must be resistant to dampness and alkalies, and paints used on steel must have rust-inhibitive properties.
Purchase paint pan liners 5 for about $5. Once your done simply throw the liner out saving your paint pan and also giving you the opportunity to change paint colors without having to clean and dry the pan.