Plastic sheathing and masking tape was not available at the end of the painting project for whatever reason, I have no idea, but you have a Paint Brush that if not cared for will eventually dry up. Last solution that works well, is to take a sopping wet rag, wrapping the Paint Brush up like that burrito you missed wrapping up earlier. This will buy you some time until either you use the paint brush again, or you can properly clean it.
Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled.
Step three: go online and study the basics of shadow and light. It's a visual thing, and too complicated to talk about here. But once you see it, it'll come to you quickly. Simply Google "shadow and light in painting" and the basics will come up. Once you know these rules, you can apply it to any shape, any form, any painting. And it'll make you keenly aware of shadow and light on virtually any object on earth. It's what makes a painting three- dimensional and expensive looking. You can also buy art books on shadow and light at any bookstore. But make sure you sit down for a couple of hours and study it. It will come quickly to you, I promise.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
Alkyd is an old interior paint made newly popular by a change in solvent - a super-refined petroleum chemical that has almost no odor. It is not a water paint. You thin it and clean brushes with mineral spirits or turpentine, or, if you want to retain the odorless feature, with the new odorless solvent. (Ask the paint-store man for just that, odorless solvent).
A large whitewash brush is best for applying the wash. One should not attempt to brush out the coating, as in applying oil paint, but simply spread the whitewash on as evenly and quickly as possible.
The principal ingredient in whitewash is lime paste. A satisfactory paste can be made with hydrated lime, but better results are obtained by using quicklime paste that has been slaked with enough water to make it moderately stiff. The lime paste should be kept in a loosely covered container for at least several days. Eight gallons of stiff lime paste can be made by slaking 25 lbs. of quicklime in 10 gallons of water, or by soaking 50 lbs. of hydrated lime in 6 gallons of water. After soaking, the paste should be strained through a fine screen to remove lumps or foreign matter.