The paints may be applied by brush or spray; the small spray attachment for vacuum cleaners is very convenient, especially for painting radiators. The term paint is used to include paints, varnishes, enamels, shellacs, lacquers, and stains. • Paints are composed of mineral pigments, organic vehicles, and a variety of thinners all combined. • Varnishes are resins dissolved in organic thinners. • Enamels are pigmented varnishes. • Shellac is lac gum dissolved in alcohol. • Lacquers may be both pigmented or clear - the liquid portion usually is treated nitrocellulose dissolve in thinners. • Stains may be pigmented oil or a penetrating type. Many of these materials, such as paints, varnishes, and lacquers, are formulated for specific purposes: • Outside house paints and exterior varnishes are intended to give good service when exposed to weathering • Interior wall paints are formulated to give excellent coverage and good wash-ability. • Floor enamels are made to withstand abrasion. • Lacquers are formulated for rapid drying. • There are also formulas which provide extra self-cleaning, fume- resisting, waterproofing, hardening, flexibility, mildew-resisting, resistance to fading, and breathing qualities. If you are grappling with the problem of choosing a woodwork colour to go with neutral walls, check out Architectural Colours by David Oliver, the founder of Paint & Paper Library. He arranged his off-whites for ceilings, cornices, walls and woodwork in chromatical groups and the concept has been so well received that chromatically arranged colours, such as soft greys, greens and pinks, have been introduced.
Akbar (1556-1605) was the one who started encouraging of Mughal artist. After he had consolidated his political power, he built a new capital at Fatehpur Sikri where he collected artists from India and Persia. More than a hundred painters were employed, most of whom were Hindus from Gujarat, Gwalior and Kashmir. They worked under the two Persian master-artists Abdus Samad and Mir Sayyid Ali, but they were encouraged and inspired by Akbar. Airless Tip: If you have somebody who can start masking off the trim, have them start on that while you convert the airless to a new color. When changing colors with an airless paint sprayer it is a good idea to have a second bucket filled half way with clean water. Place the intake hose in the clean water gently without getting the old color everywhere in the water. Take the tip out of the airless and spray all of the old paint out of the hose and back into its original paint bucket. Be careful when doing this that you recognize when the paint starts turning watery. When it does point the gun into the first bucket and spray until it looks pretty clean. It doesn't need to be perfectly clean. When it looks good, clean off the intake line in the clean bucket and get the old color off the intake line. Now place the intake line inside of your new trim paint. Always use a sanding block for flat surfaces. Just your hand behind a thin piece of sand paper can leave grooves and low spots. It's also easier on your hands. For inside curves try wrapping the sand paper around a short section of garden or heater hose. This will help approximate the concave curve and help stay away from sanding through hard edges. On hard edges, like the top ridge of a fender or leading edge of a hood, you need to do this by hand. A sanding block will quickly dig right through the paint on a hard edge and take you down to bare metal. This means primer and more sanding. Treat yourself to a good lunch and forget the diet. It is amazing what some pizza or a good burger will do for the afternoon painting push.