The paints may be applied by brush or spray; the small spray attachment for vacuum cleaners is very convenient, especially for painting radiators.
Plastic sheathing and masking tape was not available at the end of the painting project for whatever reason, I have no idea, but you have a Paint Brush that if not cared for will eventually dry up. Last solution that works well, is to take a sopping wet rag, wrapping the Paint Brush up like that burrito you missed wrapping up earlier. This will buy you some time until either you use the paint brush again, or you can properly clean it.
You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed.
SECONDARY COLORS. When you mix two primary colors together, you get a secondary color. The secondary colors are orange, green and violet. Orange is made by mixing red with yellow. Green is made by mixing blue and yellow. Violet is made my mixing blue with red.
Painting ceiling does not require premium paint. You can use flat $15 to $20 ceiling paint. I use Sherwin Williams PRO-MAR 200. Painting ceiling requires a lot of physical work and plenty of drop cloths. If you are not up for the challenge or have very high ceilings contacted a professional will prove to be a smart move.
There are two bases of paint for your house: solvent-based (oil or alkyd) and water-based (latex). Oil-based paints dry slow - usually taking up to 24 hours. The best clean up for an oil-based paint is turpentine or paint thinner. Latex paints' advantage is that it dries relatively fast, but it is not desirable in hot weather or direct sunshine. The best clean up for latex paints requires just soap and water. So if you are painting the inside of your house, it is recommended to use water-based paints, while solvent-based paints are suggested for painting the exterior of your house.
For localities where such conditions exist, self-cleaning paints should be selected. These paints are usually so designated on the label. Concrete, plaster, and metal surfaces each present special problems in painting. For instance, paint for use on masonry or new plaster must be resistant to dampness and alkalies, and paints used on steel must have rust-inhibitive properties.